The maintenance and upkeep of tension testers mainly include the following aspects:
Regular cleaning: Use a clean soft cloth to wipe the surface of the instrument, avoiding the use of chemical and organic solvents to prevent damage to the protective layer on the surface. For core components such as measuring probes and sample tanks, they should be regularly cleaned with distilled water or anhydrous ethanol, and stubborn stains should be treated with ultrasonic cleaners.
Calibration and debugging: Regularly calibrate to ensure measurement accuracy. It is generally recommended to perform calibration and maintenance every three to six months, including load calibration, speed calibration, and force calibration. For applications that require precise measurement, it is recommended to establish calibration curves and improve the accuracy of measurement results by comparing standard solutions with known tension values and instrument measurements.
Storage environment control: The tension tester should be stored in a dry, ventilated, and non corrosive gas environment, avoiding direct sunlight and humid conditions. The room temperature should be maintained at 20-25 degrees Celsius, and the relative humidity should be controlled at 40% -60% to ensure stable instrument performance.
Moisture and dust prevention: The instrument contains precision electronic and optical components inside, which are highly sensitive to humidity and dust. Therefore, it is necessary to ensure that the instrument is stored in a relatively dry and dust-free environment, and regularly powered on to keep the internal components dry.
Avoid severe vibrations: Severe vibrations may cause damage to the internal structure of the instrument and affect the accuracy of measurements. During transportation, storage, and use, the vibration of the instrument should be minimized as much as possible.
Power and cable management: Ensure stable power supply for the instrument and avoid the impact of power fluctuations on measurement results. At the same time, regularly check whether the cables are damaged or loose, and replace them in a timely manner if there are any abnormalities.
Regular inspection: Regularly inspect the key components of the instrument, such as circuits, light sources, sensors, etc., to ensure the normal operation of the instrument. Pay special attention to the cleanliness of the liquid tank and sensor, and promptly clean any dirt or residue.

